Instruction Manual

<Appendix D Action of External Input and Output Signals>
App.D-5
IM 11B08A01-01E
11/11/22
15:15:45
GCM Setup (2/2)
11/11/22
15:15:45
GCM Setup (2/2)
GCM # 1 GCM # 1
> - ATM valve number 1-1 > - ATM valve number 1-2
Strm identifying Up to 7 streams Strm identifying Up to 7 streams
-
1st num StrIdentify DO Slot #4 -#1 - 1st num StrIdentify DO Slot #5 -#1
- 1st num StrValve 1 - 1st num StrValve 4
- Stream valve num 3 - Stream valve num 3
- Distillation None - Distillation None
Menu GCM# Menu GCM#
F1 F2 F3 F4 F5 F6 F1 F2 F3 F4 F5 F6
Figure 5
Stream Identifi cation Signal Output: Exist (GCM Setting Screen on GC-HMI EtherLCD)
Table 5 shows an example of analog output settings.
Figure 6 illustrates respective actions.
Table 5 Example of Analog Output Settings
Output stream #1 Output peak #1 Output stream #2 Output peak #2
A/O1 1 1 2 1
A/O2 1 2 2 2
A/O3 1 3 2 3
A/O4 1 4 2 4
F0502.ai
*1 2s4s 2s4s 2s4s 2s4s*1 *1 *1
Stream 1
End of Analysis
Stream 2
End of Analysis
Stream 1
End of Analysis
Stream 2
End of Analysis
AO1
AO2
AO3
AO4
DO3
(Stream
identification
flag)
DO4
(Stream
identification
signal)
DO5
(Stream
identification
signal)
Analog Hold Output Contact Output
End of Analysis: Time when the final peak detection is completed or peak detection stop time.
*1: One to two seconds (depending on analysis specifications)
End of Analysis: End of peak detection time in SYS method
*1: One to two seconds (depending on analysis specifi cations)
Figure 6 Example of Actions of Analog Output
2nd Edition : May 11, 2012-00
App.D