Instruction Manual

<5. EtherLCD>
5-93
IM 11B08A01-01E
5.4.23 SYS Setup
 Valve set
11/11/22
15:15:45
SYS Setup (1/4)
11/11/22
15:15:45
SYS Setup (2/4)
SYS # 1 Oven # 1 Valve SYS # 1 Oven # 1 Det
> - Valve 1-1 Yes > - Det 1-1 ( TCD ) Yes
- Valve 1-2 - - - - Det 1-2 ( TCD ) - - -
- Valve 1-3 - - -
- Valve 1-4 - - -
- Valve 1-5 - - -
- Valve 1-6 - - -
- Valve 1-7 - - -
Menu SYS# Oven# Menu SYS# Oven#
F1 F2 F3 F4 F5 F6 F1 F2 F3 F4 F5 F6
11/11/22
15:15:45
SYS Setup (3/4)
11/11/22
15:15:45
SYS Setup (4/4)
SYS # 1 Oven # 1 EPC SYS # 1 Oven # 1 Oven
> - Carrier 1-1 - - - > - Oven 1 ( Isothermal ) Yes
- Carrier 1-2 - - - - Oven 2 ( Program ) No
- Utility 1-1 - - - - Oven 3 ( Not provided ) - - -
- Utility 1-2 - - -
- Utility 1-3 - - -
- Utility 1-4 - - -
Menu SYS# Oven# Menu SYS#
F1 F2 F3 F4 F5 F6 F1 F2 F3 F4 F5 F6
Figure 5.106
Example of SYS setup screen
F1 (Menu): Displays the Table menu screen.
F5 (Sys #): Specifi es a SYS number.
F6 (Oven #): Specifi es an Oven number.
Press F5 (SYS#), and “SYS No.:” is displayed in the second line below.
Use the numeric keypad to input the number and press the Set/Ent key, and the SYS contents of
the number is shown.
Press F6 (Oven#), and “Oven No.” is displayed in the second line below.
Use the numeric keypad to select the number and press the Set/Ent key, and it is refl ected in the
second line above, and the valve set of the specifi ed oven is completed.
Point a cursor to the valve and press the Set/Ent key, and options are displayed in the second
line below.
Select either Yes or NA (NA is default)
Not installed valves are displayed as ----.
When any of the Not installed valves is used by other SYS, **** is displayed.
2nd Edition : May 11, 2012-00
5