Instruction Manual

<5. EtherLCD>
5-70
IM 11B08A01-01E
Table 5.4 Peak synchronization and peak copy items
Name Peak Synchronization Peak Copy
Absolute peak number 1
Peak name
 ×
Stream number × ×
Relative peak number × ×
Peak execution  × *1
Always set copy target to Not executed.
Detector number or SYS number 
Process assign 
DCS output fl ag  ×
Ref Peak 1
Stream number

Peak number 
Ref Peak 2
Stream number

Peak number 
Measuring range 
Unit 
Normalization 
Factor 1
<1000-fold data>
Factor K, Factor a, Factor f
<10000-fold data> Compress fact.(air)
<100-fold data> Temp.(degC)

Factor 2
<1000-fold data>
Factor A, Factor b, RVP coef A, 0%
value, Area %, Std B.P

Factor 3
<1000-fold data>
Factor B, RVP coef B, 100% value

Factor 4
<1000-fold data> Std conc
<100000-fold data>
Set up Conc.

Range number  ×
Gate cut method 
Auto tracking req 
Peak polarity 
Detected slope 
Detection level 
A/H req 
Integ method 
Cal method req  ×
Chrom gain req (Auto gain value) 
Peak std time 
Gate ON Time 
Gate OFF Time 
Linear Calc 1 factor 
Linear Calc 2 factor
<10000-fold data> Section set stop

Linear Calc 3 factor 
Linear Calc 4 factor 
Linear Calc 5 factor
<10000-fold data>
Calib factor, Response factor

Std area 
Min peak width  ×
Min peak height  ×
Min peak area  ×
Modbus address × ×
Tracking Factor a × ×
Tracking Factor b × ×
2nd Edition : May 11, 2012-00