Instruction Manual

<5. EtherLCD>
5-64
IM 11B08A01-01E
5.4.9 Peak Setup-Specifi c
11/11/22
15:15:45
Peak Setup-Specifi c (1/4)
11/11/22
15:15:45
Peak Setup-Specifi c (2/4)
Stream #1 Peak #1 Stream #1 Peak #1 Indirect
Using/Assigned peak num 1 / 10 > - Detector number 1-1
> - Process (Type) Peak - Measuring unit 1 ( )
- Process (Detail) Indirect - Measuring range 1.000
- Name A - Gate cut method Time gate
- Execution Not excuted - Integ method Skimming
- Synchronize to #01 #001 - Peak polarity Positive
- Output fl ag Provided (31001) - Detected slope * * * * * * * *
- Range number 0
- Auto gain value 0
Menu Copy1 Copy2 Strm# Peak# Menu Copy1 Copy2 Strm# Peak#
F1 F2 F3 F4 F5 F6 F1 F2 F3 F4 F5 F6
11/11/22
15:15:45
Peak Setup-Specifi c (3/4)
11/11/22
15:15:45
Peak Setup-Specifi c (4/4)
Stream #1 Peak #1 Indirect Stream #1 Peak #1 Indirect
> - Gate ON time 1.0 s > - Linear calc 1 factor 0.0000
- Gate OFF time 5.0 s - Linear calc 2 factor 0.0000
- A/H req Area - Linear calc 3 factor 0.0000
- Normalization * * * * * * * * * * * * - Linear calc 4 factor 0.0000
- Response factor 2.000 - Linear calc 5 factor 2.0000
- Min peak width * * * * * *
- Min peak height * * * * * *
- Min peak area * * * * * *
Menu Copy1 Copy2 Strm# Peak# Menu Copy1 Copy2 Strm# Peak#
F1 F2 F3 F4 F5 F6 F1 F2 F3 F4 F5 F6
Figure 5.78
Example of peak setup-specifi c screen
F1 (Menu): Displays the Table Menu screen.
F2 (Copy1): Displays the Peak copy 1 screen.
F3 (Copy2): Displays the Peak copy 2 screen.
F5 (Strm#): Specifi es the Stream number.
F6 (Peak#): Specifi es the Peak number.
• When using F1 (Menu) to move to other screen and then return to the Peak Setup-Specifi c
screen again, the screen for the previously displayed stream number and peak number
appears. However, when peak assignment has been changed in the Peak Assigments
screen, the screen for Stream 1/Peak 1 appears.
2nd Edition : May 11, 2012-00