Instruction Manual

<4. GC-HMI (touch panel)>

4-31

IM 11B08A01-01E

Figure 4.37

TIP

• The selections Str. Sequence, Specify str., Cal (Val), Start cal (val), and Finish cal (val) are enabled for user

level B or higher.

• The selections Cancel spec., Cal (val) method, and Start/stop auto cal are enabled for user level C or higher.

• If Cal (Val) method is set to Manual or Semi-auto for all calibration/validation numbers, the Start/stop auto cal

parameter cannot be set.

(2) Changing GCM settings

a. Peak Setting

Set parameters related to peak recognition.

TIP

• This operation is available if the user level is set to C or higher.

• The stream number, SYS number, and peak number assigned to the active GCM are selectable here.

2nd Edition : May 11, 2012-00