Owner manual

4-18

IM 11B03A03-01E

• Semiautomatic Validation

The same action is performed when the validation is specified at any timing during analy-

sis.

(1) An action when Validation 1 is specified while the measurement status is in Stream

Sequence 1 and the operation mode is in Run, is shown in Figure 4.21.

W9 W3 W1 W2W2

S1 S2 S9

S9 S3 S1

Select the Validation 1

Time

Stream Sequence 1 Stream Sequence 1Validation 1

S1 to 9: Analysis cycles for streams 1 to 9

W1 to W9: Warming up time for streams 1 to 9

F0421.EPS

Figure 4.21 Action of Semiautomatic Validation (1)

(2) An action when Validation 1 is specified while the measurement status is in Stream

(continuous) 1 and the operation mode is in Run, is shown in Figure 4.22.

W9 W1 W1 W1W1

S1 S1 S9

S9 S1 S1

Select the Validation 1

Time

Stream (Cont) 1 Stream (Cont) 1Validation 1

S1, 9: Analysis cycles for streams 1 and 9

W1, W9: Warming up time for streams 1 and 9

F0422.EPS

Figure 4.22 Action of Semiautomatic Validation (2)

(3) When Validation 1 is specified while the measurement status is in Stream Sequence 1

to 4 or in Stream (continuous) 1 to 31 and the operation mode is in Stop or in Pause,

the measurement status is immediately changed to Validation 1 and then Validation 1

is performed. After Validation 1 has been completed, the previous measurement

status is retrieved and the operation mode turns to Stop. The same action is per-

formed when Validation 2 or 3 is specified.

3rd Edition : Aug. 23. 2006-00