Owner manual

4-13

IM 11B03A03-01E

4.4.3 Actions of Stream (1 cycle)

Stream (1 cycle) 1 to 31 is allowed to be specified only when the measurement status is in

Stream Sequence 1 to 4. The same action is performed when the Stream (1 cycle) is

specified at any timing during analysis.

(1) When Stream (1 cycle) 1 to 31 is specified while the measurement status is in Stream

Sequence 1 to 4 and the operation mode is in Stop or in Pause, the specified stream

is measured once and then the measurement status turns to Stream Sequence 1 and

the operation mode returns to Stop.

(2) An action when Stream (1 cycle) 4 is specified while the measurement status is in

Stream Sequence 1 and the operation mode is in Run, is shown in Figure 4.12.

W3 W1 W2 W3W2

S1 S2 S3

S4 S1 S2

Select the Stream (1 cycle) 4

Time

Stream Sequence 1 Stream Sequence 1Stream (1 cycle) 4

S1 to S4: Analysis cycles for streams 1 to 4

W1 to W4: Warming up time for streams 1 to 4

F0412.EPS

Figure 4.12 Action of Stream (1 cycle)

3rd Edition : Aug. 23. 2006-00