Manualshelf

Instruction Manual

ManualsBrandsYokogawa ManualsAir equipmentGC1000 Mark II Process Gas Chromatograph
11121314151617181920
<4. Engineering>
4-2
IM 11B06F01-01E
l Setting the system card
Set the system compact ash card for FCN to PC by USB adaptor.
Run the following batch le.
[Uncompressed folder]/INSTALL_ASIU/install_ASIU.bat
This batch le sets the ASIU application and system setting le on the system card.
System setting le includes initial IP address setting.
The initial IP address can be changed later.
After writing, the system card set on the CPU card of FCN, and turn on the FCN.
Initial IP address = 192.168.1.101
NOTE
Do not format the system compact ash card. The card becomes invalid and new one is required.
l Initializingwithresourcecongurator
The method of initial setting operation with resource congurator is described on the instruction
manual of FCN.
The work ow is described in this chapter. However, refer to the instruction manual for details of
each operation.
(1) Setting the IP address
Refer to 4.3.1 Modication of IP address.
(2) Downloading the license le
Download the license le that is loaded from the STARDOM web site to ASIU with the re-
source congurator.
Refer to on-line help of resource congurator.
(3) Setting the network
Specify the Ethernet connection for ASIU if it is single or duplex.
Ethernet of ASIU has dual or single type and dual type has duplex and separated mode.
After completing the above 3 items, download the information by [File] - [Download].
Reboot the ASIU by pressing Reset button or Web browser. After starting ASIU conrm that
the IP address is correct by ping command of PC.
(4) Assignment of I/O terminal and application
ASIU application reads the data to access Device Label, which is DI variable, DO variable
and AI variable. It is accessible by assignment of Device Label into I/O terminal. The Device
Label has no relation with I/O terminal at the initial installation. Refer to 4.2.1 Assignment of
I/O terminal.
(5) Setting the serial port
In the case of Modbus RTU, the communication parameters should be adjusted to a con-
nected device.
Refer to 4.3.2 Modication of serial port setting.
4th Edition : Nov. 22, 2011-00