Operation Manual

<4. Preparation>

4-26

IM 01C25R51-01E

Step 2 Select Default Scan Segment

Specify whether to automatically scan HART devices/Foundation Fieldbus H1 devices after

tartup.Select[HART]or[F

OUNDATIONeldbus]andclick[OK].

Figure 4.31b Select HART/FOUNDATION eldbus

NOTE

Thesoftwareforthecommunicationdevicestartsautomaticallywhen[FOUNDATIONeldbus]is

selectedat[FieldMate].RefertoAppendixD-3forhowtostartthesoftware.

Step 3 FieldMate Segment Viewer window

OpenSegmentVieweronFieldMate.

AdeviceiconappearsonthewindowifitissuccessfultoconnecttoFieldMate.Ifnot,“Nodevice

found” message is shown on the window.

If a connected device icon does not appear, check that initial setting for communication is

correctly done. Refer to section 4.4 for HART and 4.5 for F

OUNDATIONeldbus.

Figure 4.31c Segment Viewer