Operation Manual

<8. Operation of DYFMVTool>
8-22
IM 01C25R51-01E
8.3.2 Case2: AR Block is Connected with Other Devices
TheproceduresbelowareforconrmingowcongurationwhenARBlockisconnectedwith
other devices.
Step 1 Set function block scheduling information
Set the function block scheduling information to activate digitalYEWFLO AR Block and the
connected function block. Regarding function block scheduling, refer to Appendix B-2.
Step 2 Set function block connection information
Connect the function block output to digitalYEWFLO AR Block input. Regarding function block
connection, refer to Appendix B-2.
Step 3 Open Online Parameter in Device DTM
Start Device DTM to display the Online Parameter screen.
(
[Device]→[Parameter]→[OnlineParameter])
IMPORTANT
TurnonthealarmoutputofARBlockatTB:ALARM_PERFORM.
Default setting for the alarm output of AR Block is off.
(
[OnlineParameter]→[TransducerBlock]→[Alerts])
IMPORTANT
Conrmthesettingsin"VolumetricFlowUnit","TemperatureUnit"and"PressureUnit".
Regarding"TemperatureUnit","PressureUnit",refertosection8.1.1.
([OnlineParameter]→[Arithmetic]→[Conguration]→[DensityFactorParameters])
Step 4 Set input conditions in Connected Device’s AI Block
Set the value in the following input parameters (Refer to Figure 8.19 and Table 8.12):
I
nputthevaluesofvolumetricowrate,temperature,andpressureinManualmodeor
Simulation mode of Connected Device’s AI Block.