Operation Manual

<8. Operation of DYFMVTool>
8-11
IM 01C25R51-01E
8.1.4 Fluid Operating Range Setup
(1) Gas
Figure 8.9 Fluid Operating Range Setup screen (1)
Input operating ranges and select units
Pressure and Temperature units are selectable from following.
Pressure unit: kPa abs, bar abs, psi abs, kPa gauge, bar gauge, psi gauge
Atmospheric Pressure unit: psi abs, bar abs, kPa abs
Temperature unit: degC, degF, Kelvin
Input Base Condition and select units
Pressure and Temperature units are selectable from following.
Pressure unit: kPa abs, bar abs, psi abs, kPa gauge, bar gauge, psi gauge
Temperature unit: degC, degF, Kelvin
NOTE
• Afterclickingthe[Next]button,ifa“Thespeciedoperatingconditionincludesbothgas
and liquid phases.” information message is displayed, the operating condition is near the
acceptable limits for liquid and gas.
Figure 8.10 Warning message
• Pleaseconrmthedensityvalueonthefollowingpage(uidphysicalpropertysetuppage)
andcontinueconguration.
• Ifthetemperatureandpressurerangeinputonthe“FluidOperatingRangeSetup”istoo
wide, there is a probability of the calculation error of density is big.
• T
hese ranges are used only for the density and viscosity calculation.
• Ranges of Flowmeter are not changed.