Operation Manual

<7. Operation of EJXMVTool>
7-20
IM 01C25R51-01E
Table 7.12 Symbol
# Symbol Description
1 Qm Mass Flow
2 Qv V
olumeFlow
3 Qv_norm N
ormal·StandardVolumeFlow
4 Nc Unit convert factor
5 Kfactor B
asicowCalculationfactor
6 C D
ischargeCoefcient
7 ε Expansion Factor
8 β Diameter Ratio
9 d D
iameteroforice
10 ∆p Differential Pressure
(Transmitter Setting unit)
11 ρb Base Density on Tb, SPb Condition
12 ρnorm Density on Normal, Standard condition
13 Tb Reference temperature unit: K
14 T Temperature unit: K
15 SPb Reference static pressure unit: kPa abs
16 SP Static Pressure unit: kPa abs
17 Temp K1 The density rate of change per temperature 1degC of a density base value
(value which set 100% to 1)
F
orvolumeow:set0.
18 K Compressibility factor
(2) Liquid
Figure 7.20 Basic Mode Setup for Liquid
• Input Reference Temperature (Tb), Kfactor, Temp K1
• Input Reference static pressure to 0. (This factor is used for gas)
NOTE
RetertoIM01C25R01-01Eforthecalculationoftheseowfactors.