Operation Manual

<7. Operation of EJXMVTool>
7-12
IM 01C25R51-01E
7.1.5 Fluid Operating Range Setup
(1) Gas or Steam (excluding Category: Saturated steam),
Figure 7.9 Fluid Operating Range Setup Screen (1)
Input operating ranges and select units
Pressure and Temperature units are selectable from following.
Pressure unit: kPa abs, bar abs, psi abs, kPa gauge, bar gauge, psi gauge
Atmospheric Pressure unit: psi abs, bar abs, kPa abs
Temperature unit: degC, degF, Kelvin
Input reference condition and select units
Pressure and Temperature units are selectable from following.
Pressure unit: kPa abs, bar abs, psi abs
Temperature unit: degC, degF, Kelvin
NOTE
• Afterclickingthe[Next]button,ifa“Thespeciedoperatingconditionincludesbothgas
and liquid phases.” information message is displayed, the operating condition is near the
acceptable limits for liquid and gas.
Figure 7.10 Warning message
• Pleaseconrmthedensityvalueonthefollowingpage(uidphysicalpropertysetuppage)
andcontinueconguration.
• If the temperature and pressure range input on the Fluid Operating Range Setup is too wide,
there is a probability of the calculation error of density is big.
• T
hese ranges are used only for the density and viscosity calculation.
• Ranges of Transmitter are not changed.