User guide

IM 12D08E02-01E
10-4 Appendix
10-6. User setting table
FUNCTION SETTING DEFAULTS USER SETTINGS
Parameter specific functions
01 *SC.RES 0 SC
03 *0.10xC 0.10xC Factor
C.C.1 1.000 /cm
C.C.2 1.000 /cm
04 *AIR Perform zero calibration
05 *POL.CK 1 On
Temperature measuring functions
10 *T.SENS 0 Pt1000
11 *T.UNIT 0 °C
12 *T.ADJ 1 None
*T.ADJ 2 None
Temperature compensation functions
20 *T.R.°C 25 °C
21 *T.C.1 2.1 %/°C
*T.C.2 2.1 %/°C
22 *MATRX None, see 5-2-5
23 *T1°C T. range See sep. table, §10-2
24 *L1xT1 Cond. C1 See sep. table, §10-2
25 *L2xT1 Cond. C2 See sep. table, §10-2
26 *L3xT1 Cond. C3 See sep. table, §10-2
27 *L4xT1 Cond. C4 See sep. table, §10-2
28 *L5xT1 Cond. C5 See sep. table, §10-2
mA outputs
30 *mA 1.1 both 4-20mA
31 *OUTP.F 1.1 SC1 & SC2.
*D/R 0 Reverse (control)
32 *BURN 0.0 both off
33 *RG.mA2 prop band only for PI control
34 *tI.mA2 integ. time only for PI control
35 *TABL1 21 pt table see code 31, §10-1
36 *TABL2 21 pt table see code 31, §10-1
37 *DAMP 0 sec Output damping
Contacts
40 *S1 2.0.1 high SC1 Al.
41 *S2 1.0.1 low SC2 Al.
42 *S3 0.0.0
43 *S4 4.0.0 FAIL
44 *D.TIME 0.2 sec
*SC.HYS 2.0 % setpoint value
*T. HYST 1 °C
*C.HYST 0 % setpoint value
45 *RANGE 1 % output span
*PER 10 sec
*FREQ 70 p/min
46 *tI.CNT 100 sec
47 *EXPIR 0 off
*tE.min 15 min
48 *SC1 0 100µS/cm control range
0 20MΩ•cm
*SC2 0 100µS/cm control range
0 20MΩ•cm