Instruction Manual

<8. Operation of DYFMVTool>
8-15
IM 01C25R51-01E
8.1.6 Apply Flow Conguration
Figure 8.15 Apply Flow Conguration Screen
Inordertodownloadthecongurationtothedevice,click“Apply”.
Thenperform“DownloadtoDevice”fromDeviceDTM.(Refertosection6.2.3)
ExecuteApplyforsettingcompensationconditioninOfine.
Refer to Chapter 5 and Figure 6.3.
NOTE
Followingshows“DeviceGeneralParameters”whichisappliedto“OfineDatabase”.
Table 8.8 “Device General Parameters” applied to “Ofine Database”
Detail Compensation Mode
Gas temperature pressure
compensation (Detail)
Liquid temperature
compensation (Detail)
Arithmetic Type Applied Applied
Bias A
pplied(Always"0") Applied(Always"0")
Gain A
pplied(Always"1") Applied(Always"1")
Bias Input 1 A
pplied(Always"0") Applied(Always"0")
Gain Input 1 A
pplied(Always"1") Applied(Always"1")
Bias Input 2 A
pplied(Always"0") Applied(Always"0")
Gain Input 2 A
pplied(Always"1") Applied(Always"1")
Output Range.Unit Index Applied Applied
V
olumetricFlowUnit Applied Applied
Temperature Unit —
*1
—
*1
Base Temperature — —
Pressure Unit —
*1
—
Base Pressure abs — —
Density Unit Applied Applied
Base Density Applied Applied
Deviation — —
First Temperature Coef. — —
Second Temperature Coef. — —
Applied:TargetparameterisappliedbyDYFMVTool
*1: TemperatureUnitandPressureUnitinARBlockarenotconguredbyFlowCongurationWizardDetail
Compensation Mode.
SetmanuallyusingOfineParameter.Refertosection8.1.1.