Instruction Manual

<4. Installation>
4-6
IM 01C27H01-01EN
The transmitter section can be rotated
approximately 360° (180° to either direction or
360° to one direction from the original position at
shipment, depending on the conguration of the
instrument.) It can be xed at any angle within
above range.
1) Remove the ve setscrews that fasten the
transmitter section and capsule assembly,
using the Allen wrench.
2) Rotate the transmitter section slowly and stop it
at designated position.
3) Tighten the ve setscrews to a torque of 1.5
N·m.
IMPORTANT
Do not rotate the transmitter section more than
the above limit.
F0410.ai
Transmitter section
Rotate 180°segments
Pressure-detector section
Figure 4.10 Rotating Transmitter Section
4.7 Changing the Direction of
Integral Indicator
WARNING
Intrinsic safe type transmitters must be, as a
rule, remove a battery pack in non-hazardous
area before open/close the Amplier Cover or
disassembling and reassembling the Integral
Indicator.
An integral indicator can be rotated in four positions
at 90°. Follow the instructions in section 8.4.1 for
removing and attaching the integral indicator.
4.8 Changing the direction of
the antenna
Adjust the direction of the antenna to be in the
upright position. Figure 4.11 shows factory setup
antenna position. If the transmitter is installed to
vertical impulse piping, follow the procedure below
and change the antenna position.
1) Loosen the two mounting screws at the bottom
of the antenna by using a 2.5 mm Allen wrench
(see Figure 4.11).
The screws might come off and be lost if
loosened too much; loosen the screws by about
three rotations.
2) Press forward and down 90 degrees by rotating
the axis at the bottom of the antenna.
3) Tighten the two screws to a torque of 1.5 N·m
by using a torque wrench. When doing this, be
careful not leave a gap between the antenna
and housing.
F0411.ai
Figure 4.11 Mounting Screw Position
F0412.ai
Figure 4.12 Adjusting Antenna Position