Manual

<7. Operation>
7-3
IM 01C27C01-01EN
7.3 Starting Operation
After completing the zero point adjustment, follow
the procedure below to start operation.
1) Conrm the operating status.
2) After conrming the operating status, perform
the following:
IMPORTANT
• Close the terminal box cover and the
amplier cover. Screw each cover in tightly
until it will not turn further.
• Tighten the zero-adjustment cover mounting
screw to x the cover in position.
7.4 Connecting to the Field
Wireless Network
■ Preparation work prior to connecting to a
eld wireless network
This transmitter does not need to be connected
with a physical wire. Instead of physical wiring, it
is necessary to set the eld wireless devices to
communicate with before installing the transmitter.
This procedure is called a provisioning.
This transmitter supports provisioning via infrared
communication using a provisioning device and
can be securely connected to a network. If the
provisioning information is not set, the transmitter
cannot be connected to the eld wireless network.
Provisioning:
Provisioning is work to set the security and
network information to enable the transmitter
to be connected to the eld wireless network.
This transmitter supports a provisioning method
using infrared communication.
For details on provisioning using a provisioning
device, and procedure for connecting the
transmitter to the Field Wireless Network, refer
to the User’s Manual, FieldMate Versatile Device
Management Wizard (IM 01R01A01-01E),
YFGW710 Field Wireless Integrated Gateway (IM
01W01F01-01EN) and YFGW410 Field Wireless
Management Station (IM 01W02D01-01EN).
F0704.ai
within 30cm
Figure 7.4 Provisioning Example
■ Provisioning work
This subsection describes provisioning work using
FieldMate as the provisioning device.
Provisioning work performs provisioning for each
eld wireless device using FieldMate and an
infrared adapter. If use Yokogawa-recommended
infrared device for provisioning, set distance
between the glass window surface to the infrared
device within 30cm.
For details of Yokogawa-recommended infrared
device, refer to subsection 9.2 “Calibration
Instruments Selection”.
Perform the following provisioning tasks.
• Setting provisioning information
• Creating a provisioning information le
1) Setting provisioning information
Set the device tag and network ID using a
FieldMate provisioning function. The device
tag, network ID, and join key are set in the eld
wireless device. It is not necessary to input
a join key because FieldMate automatically
generates it.
Setting device tag
The device tag is used for the user to
recognize the eld wireless device.
Setting network ID
This is the network ID for the eld wireless
network to which the eld wireless device is
connected. Set a value from 2 to 65535.
The eld wireless device is connected to the
eld wireless network corresponding to the
network ID set by provisioning work.