Manual

<10. General Specications>
10-2
IM 01C25T04-01EN
10.2 Optional Specications
For items other than those described below, refer to each User’s Manual.
Item Description Code
Data conguration at factory Software Damping CD
10.3 Optional Specications (For Explosion Protected type)
Item Description Code
Factory Mutual (FM) FM Explosionproof
*1
FF1
FM Intrinsically safe and Nonincendive
*1
—
ATEX ATEX Flameproof
*1
KF22
ATEX Intrinsically safe [Ex ia]
*1
KS26
ATEX Intrinsically safe [Ex ic]
*1
KN26
Canadian Standards
Association (CSA)
CSA Explosionproof
*1
CF1
CSA Intrinsically safe
*1
—
IECEx Scheme IECEx Flameproof
*1
SF2
IECEx Intrinsically safe
*1
—
Contact Yokogawa representative for the codes indicated as ‘-’.
*1: Applicable for Electrical connection code 2, 4, 7, 9, C and D .
< Factory Setting >
Tag Number (Tag plate) As specied in order
Software Tag (TAG) ‘PT1001’ unless otherwise both Tag Number and Software Tag
specied in order
Bus Address ‘0x7E(126)’ unless otherwise specied in order
Output Mode (Characterization Type) ‘Linear’ unless otherwise specied in order
Calibration Range (Scale In Lower/Upper Value) As specied in order
Calibration Range Unit Selected from mmH
2
O, mmH
2
O(68°F), mmHg, Pa, hPa, kPa,
MPa, mbar, bar, gf/cm
2
, kgf/cm
2
, inH
2
O, inH
2
O(68°F), inHg, ftH
2
O,
ftH
2
O(68°F) or psi. (Only one unit can be specied)
Output Scale (Out Scale Lower/Upper Value) ‘0 to 100%’ unless otherwise specied.
Software Damping (Filter Time Const)
*1
‘2 s’ or as specied in order
*1: To specify this item, /CD option is required.