Manual
<6. Explanation of Basic Items>
6-3
IM 01C25T04-01EN
Component name Contents
Bar graph Shows the value displayed in the center eld for numerical values scaled in terms of
percentage.
Center eld for
numerical values
Presents values of inputs and outputs.
While the alarm is on, the alarm number alternates with the displayed value here.
Lower text eld Displays tag, parameter name, unit, and signal status. While the alarm is on, the alarm contents
alternate.
Title eld Depicts the type of the value displayed on the center eld for numerical value.
P Flashes when pressure/differential pressure is displayed.
SP Flashes when static pressure is displayed.
T Flashes when temperature is displayed.
F Flashes when ow rate is displayed.
Auxiliary characters % Flashes when the center eld for numerical values displays a % value.
Flashes when square root display is selected.
Key mark Flashes when Write Protect is selected.
×10,
×100,
×1000
Used when the calculated value displayed in the center eld for numerical values is
rounded.
6.3.4 Example Displays of the Integral Indicator
Example display of AI1 OUT
F0603.ai
(1) Pressure Value
Block tag
(2) Pressure Value
Parameter name
(3) Pressure Value
Unit
(4) Pressure Value
Status
Example display during mechanical failure alarm
F0604.ai
Alarm number and
Error Massage (Capsule error)
Table 6.1 Parameters to be displayed on LCD
Block Name Parameter
Parameter Selection(1 to 4)
(PARAMETER_SEL(1 to 4))
DISPLAY
AI1 OUT AI1 OUT OUT
AI2 OUT AI2 OUT OUT
AI3 OUT AI3 OUT OUT
TOTALIZER TOTAL TOTAL TOTAL
SENSOR TRANSDUCER SECONDARY_VALUE_1 Pressure Value SV1
PRIMARY_VALUE Primary Value PV
CALCULATE_VALUE Calculated Value CAL.VAL
STATIC_PRESSURE_HIGH_VALUE Static Pressure (H) SP.HI
STATIC_PRESSURE_LOW_VALUE Static Pressure (L) SP.LO
TEMPERATURE_VALUE Capsule Temperature CAP.TMP
AMP_TEMP_VAL Amplier Temperature AMP.TMP