Manual

<5. Parameter Summary>
5-5
IM 01C25T01-06EN
Function Label Item Contents Default value Handling *
1
Event
Notication
Event Notication
Retry Time
HART 7
Event Notication Retry Time R
Max Update Time
HART 7
Max Update Time for Event
Notication
R
Event Debounce
Interval
HART 7
Event Debounce Interval Debounce Interval to detect
an event.
R
Acknowledge Event
Notication
HART 7
Acknowledge Event Notication W
Event Status
HART 7
Event Status 0x00 Approved event or no
event
0x10 Conguration changed
event pending
0x20 Device status event
pending
0x40 More status available
event pending
R
Event Number
HART 7
Event Number W
Time First Unack
Event Triggered
HART 7
Time First Unack Event Triggered W
Latched Cfg chng
count
HART 7
Latched Cfg chng count W
Latched Device
Status
HART 7
Device status when event occurred W
Latched Status
group 1 to 10
HART 7
Field device status when event
occured
W
Latched Ext dev
status
HART 7
Latched Device
Diagnostic Status 0
HART 7
Latched Device
Diagnostic Status 1
HART 7
Latched AO
saturated
HART 7
Latched AO xed
HART 7
Flg temp Flg temp Calculated ange temperature
value
RG
Flg Temp Coef Flg Temp Coef 0 WG
Flg Temp Lim Flg Temp Hi Alart
Val
Upper limit of Flange temperature 120 °C (deg C) WG
Flg Temp Lo Alart
Val
Lower limit of Flange temperature -40 °C (deg C) WG
*1: Handling:
R
=Read only,
W
=Read & Write,
M
=Method,
A
=Applicable for option code AL,
G
=Applicable for option code DG6,
D
=Applicable for differential pressure transmitters. Do not change these parameters for pressure transmitters.
*2: Max three Burst Messages (Burst Message 1, Burst Message 2, Burst Message 3)
*3: The default value shows MWP (Maximum working pressure) of the capsule.
Since the working pressure limit varies according to the Model, refer to the General Specications section in each user’s manual.