Manual

<5. Parameter Summary>
5-4
IM 01C25T01-06EN
Function Label Item Contents Default value Handling *
1
Display setup Bar Indicator Bar indicator Off or On On W
Chg power on info Change the LCD display when
powering on
On or Off
M
Disp Out 1 LCD output 1 PRES, PRES %,
ENGR.PRES, SP, SP %
PRES % W
Disp Out 2 LCD output 2 PRES, PRES %,
ENGR.PRES, SP, SP % or
Not used
Not used W
Disp Out 3 LCD output 3 (Ditto) Not used W
Disp Out 4 LCD output 4 (Ditto) Not used W
Disp Pres % fnctn % display mode Linear or Sq root As specied or
Linear
W
Disp Pres % Reso % display resolution Normal or High resolution Normal W
Engr exp User set exponent ---, x10, x100, x1000 --- or as
specied
W
Engr LRV User set lower range value Unit specied in Set Engr Unit As specied W
Engr point Decimal place for user set 0 to 4 2 W
Engr URV User set upper range value Unit specied in Set Engr Unit As specied W
Modify Engr Unit User set engineering unit M
Pres disp point Decimal place for differential
pressure
0 to 4 2 W
Set Engr Unit Engineering unit select M
SP disp point Decimal place for static pressure 0 to 4 2 WD
Squawk
HART 7
Squawk Specify the device under the
communication (turn the LCD
on).
M
Error log Error log Clear Clear error records M
Error log view Error records Log1 (latest) to log4 M
Event
Notication
Event Notication
Control
HART 7
Event Notication (Enable event notication on
token-passing data link layer,
Off)
Off W
Device Status
Mask
HART 7
Event Masking W
Status group 1 to
10 Mask
HART 7
Ext dev status
Mask
HART 7
Device Diagnostic
Status 0 Mask
HART 7
Device Diagnostic
Status 1 Mask
HART 7
AO saturated Mask
HART 7
AO xed Mask
HART 7
Set Event
Notication Timing
HART 7
Congure Event Notication Timing Congure Event Notication
Retry Time, Event Max
Update Time and Event
Debounce Interval
M
*1: Handling:
R
=Read only,
W
=Read & Write,
M
=Method,
A
=Applicable for option code AL,
G
=Applicable for option code DG6,
D
=Applicable for differential pressure transmitters. Do not change these parameters for pressure transmitters.
*2: Max three Burst Messages (Burst Message 1, Burst Message 2, Burst Message 3)
*3: The default value shows MWP (Maximum working pressure) of the capsule.
Since the working pressure limit varies according to the Model, refer to the General Specications section in each user’s manual.