Operation Manual

<6. PARAMETERS>
6-1
IM 01F06A00-01EN
6.1 digitalYEWFLO Parameters
The parameters are set before factory shipment.
Set the required parameter of changing fl uid,
contact out and indication of display.
6.2 Multi-Variable Type (/MV)
Parameters
Parameter item F is indicated when /MV is selected.
The parameters are set before factory shipment,
but it is necessary to set the analog output of
temperature, span of temperature output.
IMPORTANT
For the remote type, be sure to set the cable
length (F52) for remote type converter (DYA),
because of effect of the cable length.
6.3 Parameters List
This section describes the parameter of
digitalYEWFLO.
• Contents of parameters list.
Item Description
Item Parameter item number.
Name Parameter name.
R / W
(Read
and Write)
Indicates parameter attributes.
R : Display only (writing is not permitted).
W : Writing is permitted.
Data Range Shows data setting ranges for numerical value
entry.
Shows data to be selected for data selection.
( ) in parentheses, data code is shown for the
display.
Unit Engineering unit.
Remark Remarks such as a description of the contents
are given.
Initial value Indicates the initial set values.
Disp. D : Display can set parameter.
U / D L : Parameter can be set by UP LOAD and
DOWN LOAD.
(Check all parameters after setting by DOWN
LOAD.)
6. PARAMETERS