Operation Manual

<5. BASIC OPERATING PROCEDURES>
5-4
IM 01F06A00-01EN
5.3.1 Changes to Engineering Display Unit from % Display
The display mode can be changed referring to Section 6.3 “Parameters List.”
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
SET
INCSHIFT
F0504.ai
Indication of %
display.
Enter the setting
mode.
Enter the parameter
item.
Indicate “ 30 ”.
Enter the data
input item.
Indicate “ 01 ” of
engineering unit.
Ensure the setting
data.
Finish the setting.
Return to display
mode.
Press “ SET ” key.
Press “ SHIFT ” key.
Press “ INC ” key any time.
Press “ SET ” key.
Press “ INC ” key.
Press “ SET ” key.
Press “ SET ” key.
Press “ SET ” and “ SHIFT ” key.
IMPORTANT
After setting a parameter, keep the power on for
at least 30 seconds.
If the power of fl owmeter is turned off, a
parameter setting is released.