User guide

7-2
IM DR231-11E
7.2 Measured/Computed Data Output Format
(ASCII code)
The data are output in the following format by receiving TS0 + “Device Trigger (GET)” + FM0/
FM2:
DATEYYMMDDCrLf
TIMEhhmmssCrLf
S1S2A1A1A2A2A3A3A4A4UUUUUUCCC,
±DDDDDE - ECrLf
Each symbol denotes the following:
YY: Year
MM: Month
DD: Day
hh: Hour
mm: Minute
ss: Second
S1: Data status 1
E ------------- Abnormal
N ------------ Normal
D ------------ Differential input
O ------------ Over
S ------------- Measuring range is “skip” or computation channel is “off”
S2: Data status 2
Space ------- Interim data
E ------------- Last data
A1A1: Alarm status (level 1)
A2A2: Alarm status (level 2)
A3A3: Alarm status (level 3)
A4A4: Alarm status (level 4)
H
--------- Upper-limit alarm
L
---------- Lower-limit alarm
dH ----------- Upper-differential-limit alarm
dL ----------- Lower-differential-limit alarm
RH ---------- Increasing rate-of-change limit alarm
RL ----------- Decreasing rate-of-change limit alarm
UUUUUU: Unit
mV
---mV
V
--V
C -- °C
UUUUUU------- Arbitrary
CCC: Channel number
±: Data polarity (+, -)
DDDDD: Data mantissa (8 characters for the computation channel)
±99999 ----- Over data
+99999 ----- Abnormal data
E - E: Data exponent
Note
• Data in the channel not connected in the system settings, including channel numbers, are not output.
• In a channel for data computation, the channel number CCC is indicated as follows:
Stand-alone model: A01 to A30
Expandable model: A01 to A60