Owner manual

ManualsBrandsYokogawa ManualsSensorsDO30G Dissolved Oxygen Sensor

IM 12J5B3-01E

Introduction

The DO30G Dissolved Oxygen Sensor bases its principle of measurement on the galvanic-cell

method. The sensor is specically suited for continuous measurement of oxygen dissolved in

water.

Topics and information that need your special attention in handling the product are given in the

text of this manual along with cautionary notes, such as a warning or caution, depending on their

importance. Strictly observe these items from the standpoint of safety and prevention of equip-

ment damage. For a notation, such as a warning also indicated on the product, there is an alert

mark in the manual.

1. Conrming the Specications

The standard specication DO30G dissolved oxygen sensor is used to build the dissolved oxy-

gen metering system.

The DO30G sensor cable has the prescribed length. The conguration of the crimp-on terminals

are either pin-type, M4 ring-type or fork-type.

Upon arrival of the purchased product, carefully unpack it and make sure the product is com-

pletely free from any damage that may have occurred during transport. Also check the model

code indicated on the nameplate attached to the sensor cable to make sure that you received the

correct sensor. For the meaning of the model code, refer to subsection 1.2.2 on page 1-3.

Note: The model and sufx code of the sensor with standard specications is as follows.

DO30G-NN-50-

- ( : User specied alphanumeric)

2. Information Covered by This Manual

This manual covers all of the information on handling the DO30G Dissolved Oxygen Sensor

(Style B), such as instructions on installation, inspection, and maintenance and service.

Note : When system components other than DO30G have to be mentioned, descriptions of the basic system assumes that the

DO402G Dissolved Oxygen Converter is used.

Refer to the instruction manual for information on the converter connecting holders with the

DO30G and how to connect sensor cables.

Note that the instruction manuals listed in the following table are for the associated equipment

used with the EXA

DO Dissolved Oxygen Metering System.

Manuals for Associated Equipment Used with the EXA DO Dissolved Oxygen Metering Syatem

Model Title of Manual Manual No.

DO402G Dissolved Oxygen Converter IM 12J05D02-01E

DO202

2-wire Dissolved Oxygen Transmitter

IM 12J05C01-01E

FLXA21 2-wire Liquid Analyzer IM 12A01A02-01E

DO30G Dissolvecl Oxygen Sensor IM 12J5B3-01E

PH8HG Guide Pipe IM 12B7M2-01E

PB350G Angled Floating Ball Holder IM 19H1E1-01E

DOX8HS Immersion Type Holder (Style B) IM 19H1D2-01E

PH8PU1 Cleaning Pump/Tank IM 19C1E1-01E

WTB10-DO

Relay Terminal Box IM 12J05W02-01E

Note: Only the basic system of basic components are listed on the front panel.

Refer to respective instruction manual for information on recorders, annunciators and other instruments.

4th Edition : Apr 05,2011

Media No. IM 12J5B3-01E (CD) 4th Edition:Apr.2011 (YK)