User Manual

IM 12J05C01-01E
5-9 Parameter Setting
Code Display Function Function detail X Y Z Default values
Output Functions
30 Not used
31 *OUTP.F mA output functions Linear 0 0 Linear
Table 1
32 *BURN Burn function No burnout 0 0 No Burn.
Burnout downscale 1
Burnout upscale 2
Pulse burnout 3
33, 34 Not used
35 *TABLE Output table for mA
*0% Linearization table for mA in 5% steps.
*5% The measured value is set in the main
*10% display using the >, ^, ENT keys, for
... each of the 5% interval steps.
... Where a value is not known, that value may
*95% be skipped, and a linear interpolation will
*100% take place.
36-39 Not used
Code Display Function Function detail X Y Z Default values
User Interface
50 *RET Auto return No return to meas. from HOLD 0 1
Return to meas after 10 min 1
51 *P.MAN Manual pressure No manual pressure in Maint.mode 0 0
Manual pressure in Maint.mode 1
*P.% Enter Manual process pressure 0-999.9 kPa 101.3 kPa
*P.CAL Enter Cal. pressure in Maint.mode 0-999.9 kPa 101.3 kPa
52 *PASS Password Direct access to MAINT 0 0.0.0
Pass: 111 for #=1, MAINT protected by password #
333 for #=2, Direct access to COMM 0
777 for #=3, COMM protected by password #
888 for #=4, Direct access to SERV 0
123 for #=5, SERV protected by password #
957 for #=6,
331 for #=7,
546 for #=8 and
847 for #=9
53 *Err.01 Error setting Calibration not stable Soft fail 0
Calibration not stable Hard fail 1 1 Hard
*Err.02 Zero out of limits Soft fail 0
Zero out of limits Hard fail 1 1 Hard
*Err.07 Temperature sensor open Soft fail 0
Temperature sensor open Hard fail 1 1 Hard
*Err.08 Temp. sensor shorted Soft fail 0
Temp. sensor shorted Hard fail 1 1 Hard
*Err.09 Cell current abnormal Soft fail 0
Cell current abnormal Hard fail 1 1 Hard
*Err.16 Call for maintenance
Soft fail 0 0 Soft
Interval time exceeded
Call for maintenance Hard fail 1
Interval time exceeded
55 *CALL.M E16 setting No call for maintenance 0 0
Call for maint. enabled 1
*CALL .M E16 message after 1- 250 days 250
56 *UNIT PV unit Unit of measurement ppm 0 0
Unit of measurement ppb 1
Unit of measurement % sat. 2
57-59 Not used
mA