Instruction Manual
Table Of Contents
- 1. Introduction
- 2. Safety Precautions
- 3. FOUNDATION FIELDBUS
- 3-1 About Foundation Fieldbus
- 3-2 Getting started
- 3-3 Configuration
- 3-4 In-process operation
- 3-5 Device status
- 3-6 List of parameters for each block of the EXA
- 3-7 Application setting and change of basic parameters
- 3-8 Operation of each parameter in failure mode
- 4. PROFIBUS
- APPENDIX 1. LINK MASTER FUNCTIONS
- Revision Record
- Supplement

Profibus 4-15
IM 12A00A01-61E
4-4-3-3. Function Block Parameters ISC202 (continued)
Parameter Default Alternatives Unit R/W Slot, Index Data Type
(byte,bit) (bytes)
Concentration 0% 0 0~100 % R/W 4, 121 float (4)
Concentration 100% 100 0~100 % R/W 4, 122 float (4)
Concentration Table 0% 0 0~1.999 S/cm R/W 4, 123 float (4)
Concentration Table 5% 0.05 S/cm R/W 4, 124 float (4)
Concentration Table 10% 0.1 S/cm R/W 4, 125 float (4)
Concentration Table 15% 0.15 S/cm R/W 4, 126 float (4)
Concentration Table 20% 0.2 S/cm R/W 4, 127 float (4)
Concentration Table 25% 0.25 S/cm R/W 4, 128 float (4)
Concentration Table 30% 0.3 S/cm R/W 4, 129 float (4)
Concentration Table 35% 0.35 0~1.999 S/cm R/W 4, 130 float (4)
Concentration Table 40% 0.4 S/cm R/W 4, 131 float (4)
Concentration Table 45% 0.45 S/cm R/W 4, 132 float (4)
Concentration Table 50% 0.5 S/cm R/W 4, 133 float (4)
Concentration Table 55% 0.55 S/cm R/W 4, 134 float (4)
Concentration Table 60% 0.6 S/cm R/W 4, 135 float (4)
Concentration Table 65% 0.65 S/cm R/W 4, 136 float (4)
Concentration Table 70% 0.7 0~1.999 S/cm R/W 4, 137 float (4)
Concentration Table 75% 0.75 S/cm R/W 4, 138 float (4)
Concentration Table 80% 0.8 S/cm R/W 4, 139 float (4)
Concentration Table 85% 0.85 S/cm R/W 4, 140 float (4)
Concentration Table 90% 0.9 S/cm R/W 4, 141 float (4)
Concentration Table 95% 0.95 S/cm R/W 4, 142 float (4)
Concentration Table 100%
1 S/cm R/W 4, 143 float (4)
Calibration Parameters
Nominal cell constant 1.88 0.005~50 1/cm R/W 4, 30 float (4)
Calibrated cell constant 0.1 0.005~50 1/cm R 4, 89 float (4)
Calibration method Not calibrated(0) 1 point(107), 2 point(108) R/W 4, 34 unsigned8 (1)
Diagnostic Settings
E5 Limit 3 0~0.5Ω S R/W 4, 144 float (4)
E6 Limit 0.000005 0~0.5Ω S R/W 4, 145 float (4)
Conductivity exceeds
high limit (E5) Hard fail(1) Soft fail(0) 4, 150(2.4)
Conductivity exceeds
low limit (E6) Hard fail(1) Soft fail(0) 4, 150(2.5)
Temp. sensor open (E7) Hard fail(1) Soft fail(0) 4, 150(2.6)
Temp. sensor shorted (E8)
Hard fail(1) Soft fail(0) 4, 150(2.7)
Passcode Configuration
Passcode Maintenance 0 0, 111, 333, 777, 888, 123, 957, 331, 546, 847 R/W 4, 147 unsigned16 (2)
Passcode Commissioning 0 0, 111, 333, 777, 888, 123, 957, 331, 546, 847 R/W 4, 148 unsigned16 (2)
Passcode Service 0 0, 111, 333, 777, 888, 123, 957, 331, 546, 847 R/W 4, 149 unsigned16 (2)
Display Settings
Display Resolution Auto Ranging(1)
auto(1), xxx.x µS/cm(4) x.xxx mS/cm(5), xx.xx
mS/cm(6) xxx.x mS/cm(7), xxxx mS/cm(8)
R 4, 146 unsigned8 (1)
Auto return Enabled(1) Disable(0) R 4, 151(1.0)
Logbook Configuration
Power up Logbook 2(3) off(1), logbook1(2), logbook2(3) R/W 4, 59 unsigned8 (1)
Power down Logbook 2(3) R/W 4, 60 unsigned8 (1)
System error Logbook 1(2) R/W 4, 61 unsigned8 (1)
Defaults loaded Not logged(1) R/W 4, 62 unsigned8 (1)
Logbook erased Not logged(1) R/W 4, 63 unsigned8 (1)
Init performed Logbook 1(2) R/W 4, 64 unsigned8 (1)
Error on Not logged(1) R/W 4, 65 unsigned8 (1)
Error off Not logged(1) R/W 4, 66 unsigned8 (1)
Temperature adjust Logbook 1(2) R/W 4, 67 unsigned8 (1)
Cell constant Logbook 1(2) R/W 4, 68 unsigned8 (1)
Air calibration Logbook 1(2) R/W 4, 69 unsigned8 (1)