Instruction Manual
Table Of Contents
- 1. Introduction
- 2. Safety Precautions
- 3. FOUNDATION FIELDBUS
- 3-1 About Foundation Fieldbus
- 3-2 Getting started
- 3-3 Configuration
- 3-4 In-process operation
- 3-5 Device status
- 3-6 List of parameters for each block of the EXA
- 3-7 Application setting and change of basic parameters
- 3-8 Operation of each parameter in failure mode
- 4. PROFIBUS
- APPENDIX 1. LINK MASTER FUNCTIONS
- Revision Record
- Supplement
Profibus 4-13
IM 12A00A01-61E
4-4-3-2. Function Block Parameters SC202 (continued)
Parameter Default Alternatives Unit R/W Slot, Index Data Type
(byte,bit) (bytes)
Calibration Parameters
Nominal cell constant 0.1 0.005~50 1/cm R/W 4, 30 float (4)
Calibrated cell constant 0.1 0.005~50 1/cm R 4, 89 float (4)
Calibration method Not calibrated(0) 1 point(107), 2 point(108) R/W 4, 34 unsigned8 (1)
Diagnostic Settings
Polarisation check Enabled(1) Disable(0) 4, 151(2.1)
Polarization detected (E1) Hard fail(1) Soft fail(0) 4, 150(2.0)
E5 Limit 0.25 0~0.5, 0~10MΩ S R/W 4, 144 float (4)
E6 Limit 0.000001 0~0.5, 0~10MΩ S R/W 4, 145 float (4)
Conductivity exceeds
high limit (E5) Hard fail(1) Soft fail(0) 4, 150(2.4)
Conductivity exceeds
low limit (E6) Hard fail(1) Soft fail(0) 4, 150(2.5)
Temp. sensor open (E7) Hard fail(1) Soft fail(0) 4, 150(2.6)
Temp. sensor shorted (E8)
Hard fail(1) Soft fail(0) 4, 150(2.7)
USP Disabled
Conductivity exceeds
USP limit (E13) Soft fail(0) Hard fail(1) R/W 4, 150(1.4) unsigned32 (4)
Passcode Configuration
Passcode Maintenance 0 0, 111, 333, 777, 888, 123, 957, 331, 546, 847 R/W 4, 147 unsigned16 (2)
Passcode Commissioning 0 0, 111, 333, 777, 888, 123, 957, 331, 546, 847 R/W 4, 148 unsigned16 (2)
Passcode Service 0 0, 111, 333, 777, 888, 123, 957, 331, 546, 847 R/W 4, 149 unsigned16 (2)
Display Settings
Display Resolution Auto Ranging(1) auto(1), x.xxx µS/cm(2), xx.xx µS/cm(3)
xxx.x µS/cm(4), x.xxx mS/cm(5), xx.xx mS/
cm(6) xxx.x mS/cm(7), xxxx mS/cm(8) R 4, 146 unsigned8 (1)
Auto return Enabled(1) Disable(0) R 4, 151(1.0)
Logbook Configuration
Power up Logbook 2(3) off(1), logbook1(2), logbook2(3) R/W 4, 59 unsigned8 (1)
Power down Logbook 2(3) R/W 4, 60 unsigned8 (1)
System error Logbook 1(2) R/W 4, 61 unsigned8 (1)
Defaults loaded Not logged(1) R/W 4, 62 unsigned8 (1)
Logbook erased Not logged(1) R/W 4, 63 unsigned8 (1)
Init performed Logbook 1(2) R/W 4, 64 unsigned8 (1)
Error on Not logged(1) R/W 4, 65 unsigned8 (1)
Error off Not logged(1) R/W 4, 66 unsigned8 (1)
Temperature adjust Logbook 1(2) R/W 4, 67 unsigned8 (1)
Cell constant Logbook 1(2) R/W 4, 68 unsigned8 (1)
Air calibration Logbook 1(2) R/W 4, 69 unsigned8 (1)
Calibration Logbook 1(2) R/W 4, 70 unsigned8 (1)
Reference temperature Not logged(1) R/W 4, 71 unsigned8 (1)
Temperature coefficient 1 Not logged(1) R/W 4, 72 unsigned8 (1)
Matrix selection Not logged(1) R/W 4, 73 unsigned8 (1)
Temperature coefficient 2 Not logged(1) R/W 4, 74 unsigned8 (1)
User defined matrix
Temperature 1 0 -20~250, 0~500 °C R/W 4, 90 float (4)
Temperature 2 25 °C R/W 4, 91 float (4)
Temperature 3 50 °C R/W 4, 92 float (4)
Temperature 4 75 °C R/W 4, 93 float (4)
Temperature 5 100 °C R/W 4, 94 float (4)
Solution 1 at Temp. 1 0.031 0~1.999, 0~999MΩ•cm S/cm R/W 4, 95 float (4)
Solution 1 at Temp. 2 0.053 S/cm R/W 4, 96 float (4)
Solution 1 at Temp. 3 0.076 S/cm R/W 4, 97 float (4)
Solution 1 at Temp. 4 0.0975 S/cm R/W 4, 98 float (4)
Solution 1 at Temp. 5 0.119 S/cm R/W 4, 99 float (4)
Solution 2 at Temp. 1 0.061 0~1.999, 0~999MΩ•cm S/cm R/W 4, 100 float (4)