Instruction Manual
Table Of Contents
- 1. Introduction
- 2. Safety Precautions
- 3. FOUNDATION FIELDBUS
- 3-1 About Foundation Fieldbus
- 3-2 Getting started
- 3-3 Configuration
- 3-4 In-process operation
- 3-5 Device status
- 3-6 List of parameters for each block of the EXA
- 3-7 Application setting and change of basic parameters
- 3-8 Operation of each parameter in failure mode
- 4. PROFIBUS
- APPENDIX 1. LINK MASTER FUNCTIONS
- Revision Record
- Supplement
IM 12A00A01-61E
3-40 Foundation Fieldbus
* Enumerated parameters (4 bytes, 32 bits) where each bit can be set individually.
ERROR_CONFIG
0x00000800(bit 11), “conductivity exceeds high limit (E5)”
0x00000400 (bit 10), “conductivity exceeds low limit (E6)”
0x00000200 (bit 9), “temperature sensor open (E7)”
0x00000100 (bit 8), “temperature sensor shorted (E8)”
CONFIGURATION
0x00800000 (bit 23), “Auto return enabled”