Owner's manual
12-7
IM 04L31A01-01E
12
Troubleshooting
Note
• The FTP client function on the CX2000 has a timer function that drops the connection if
there is no data transfer for two minutes. If the server does not respond within this time
period, the transfer fails.
• If the FTP client function on the CX2000 detects a file with the same name at the destination,
the file is transferred with the last character (8
th
character) of the file name changed.
• For information regarding the FTP client function of the CX2000, see the
DAQSTATION
CX1000/CX2000 Communication Interface User’s Manual (IM 04L31A01-17E)
.
Communication Errors
For information regarding the communication function of the CX2000, see the
DAQSTATION CX1000/CX2000 Communication Interface User’s Manual (IM 04L31A01-
17E)
.
• Errors during Setting and Basic Setting Modes, Output Communication Command
Execution, and Setup Data Loading
Code Message
300 Command is too long.
301 Too many number of commands delimited with ‘;’.
302 This command has not been defined.
303 Data request command can not be enumerated with sub-delimiter.
350 Command is not permitted to the current user level.
351 This command cannot be specified in the current mode.
352 The option is not installed.
353 This command cannot be specified in the current setting.
354 This command is not available during sampling, calculating or controlling.
357 The setup output command cannot be executed in this conditions.
• Memory Access Errors during Setting and Basic Setting Modes and Output
Communication Command Execution
An English error message is returned via the communication interface. It is not
displayed on the screen.
Code Message
360 Output interface must be chosen from Ethernet or RS by using ‘XO’ command.
361 The memory data is not saved for the communication output.
362 There are no data to send ‘NEXT’ or ‘RESEND’.
363 All data have already been transferred.
370 Command is not permitted to the current model.
• Maintenance and Test Communication Command Errors
An English error message is returned via the communication interface. It is not
displayed on the screen.
Code Message
390 Command error.
391 Delimiter error.
392 Parameter error.
393 No permission.
394 No such connection.
395 Use ‘quit’ to close this connection.
396 Failed to disconnect.
397 No TCP control block.
12.1 Messages