Manualshelf

User guide

ManualsBrandsYokogawa ManualsSensorsData Acquisition with PID Control CX2000
31323334353637383940
31
IM 04L31A01-02E
Switching between Remote and Local Modes
The soft key menu does not show REM/LOC, if Control > Contact input-registration/
AUX(Alarm mode... > Remote setting is set to Off. Remote input cannot be used for the
target setpoint when the secondary loop of cascade control is selected or during program
control. Thus, there is no remote/local switching in these cases.
1.
Use the arrow keys to move the cursor to the desired control loop.
2.
Press the REM/LOC soft key.
A pop-up window for switching between remote and local appears.
Window for switching between
remote and local
3.
Select REMOTE or LOCAL using the up and down arrow keys.
4.
Press the DISP/ENTER key to confirm the changes.
Switching between Automatic and Manual for the Analog Retransmission Loop
You can switch the output mode for the control loop specified for analog retransmission.
When set to AUTO, the computed result of analog retransmission is output. When set to
MAN, you can set the direct output value.
1.
Use the arrow keys to move the cursor to the desired control loop.
2.
Press the MODE soft key.
A pop-up window switching between auto and manual appears.
Auto/manual switching window
3.
Select AUTO or MAN using the up and down arrow keys.
4.
Press the DISP/ENTER key to confirm the changes.
Switching the Operation Mode