Manualshelf

User guide

ManualsBrandsYokogawa ManualsSensorsData Acquisition with PID Control CX2000
21222324252627282930
30 IM 04L31A01-02E
Changing the Target Setpoint
1.
Use the arrow keys to move the cursor to the desired control loop.
2.
Press the SP soft key.
The SP modification pop-up window appears. The window shows the current target
setpoint.
Window for changing the
target setpoint
3.
Change the target setpoint using the up and down arrow keys.
4.
Press the DISP/ENTER key to confirm the changes.
Changing the Control Output
The following operation cannot be performed during auto operation, when operation is
stopped, or when the primary loop of cascade control is selected. When the operation is
stopped, the preset value is output.
1.
Use the arrow keys to move the cursor to the desired control loop.
2.
Press the OUT soft key.
The OUT modification pop-up window appears. The window shows the current
control output.
Window for changing the
control output
3.
Change the control output using the up and down arrow keys.
The control output is set to the new value at this point.
4.
Press the DISP/ENTER key to complete the procedure.
Switching the Operation Mode