User guide

29
IM 04L31A01-02E
Switching the Operation Mode
For details on the procedure for switching the operation mode, see chapter 6,
“Operations during Control Operation” in the
CX2000 User’s Manual (IM 04L31A01-01E) .
The following is a procedural example on the control group display.
Run/Stop Operation
For cascade control, the following operations can be performed only when the secondary
loop is selected.
1. Use the arrow keys to move the cursor to the desired control loop.
Cursor ( )
2. Press the RUN/STP soft key.
A pop-up window for running and stopping the operation appears.
Window for starting and
stopping operation
3. Select RUN or STOP using the up and down arrow keys.
4. Press the DISP/ENTER key to confirm the changes.
Switching between Auto, Manual, and Cascade Control
You can only switch to the cascade mode on the secondary loop of cascade control.
1. Use the arrow keys to move the cursor to the desired control loop.
2. Press the Mode soft key.
The MODE selection pop-up window appears.
MODE selection window
3. Select AUT (auto), MAN (manual), or CAS (cascade) using the up and down arrow
keys.
4. Press the DISP/ENTER key to confirm the changes.