Instruction Manual

1-1
IM 04L41B01-65EN
1
2
3
4
Index
Before Using the DAQSTANDARD
1.1 Overview of the DAQSTANDARD
The DAQSTANDARD consists of the following three utility programs.
• Launcher
• HardwareCongurator
• DX100P/DX200PHardwareCongurator
ThismanualexplainsViewer.
Viewer
Viewerdisplaysthevaluesandwaveformsofthemeasureddatafromtherecorderand
prints them.
Hardware Configurator
HardwareConfiguratorisasoftwareapplicationforcreatingsetupdatafortherecorder.
It can send setup files that you have created to the recorder and save them to storage
media. It can be used with the following recorders: the DX1000, DX1000N, DX2000,
DX100,DX200,CX1000,CX2000,MV1000,MV2000,MV100,andMV200.
DX-P Hardware Configurator
DX100P/DX200PHardwareConfiguratorisasoftwareapplicationforcreatingsetupdata
fortheDX100P/DX200Precorder.Itcansendsetupfilesthatyouhavecreatedtothe
recorder and save them to storage media.
About DX-P Hardware Configurator
Confirming the Setup Data
YoucanusetheHardwareConfiguratortodisplayandconfirmthesetupdata.
Creating Setup Data
You can create new setup data by editing the opened setup data. However, the setup
data of login information and batch system settings cannot be created.
• Createnewsetupdata.
• Youcanalsocreatesetupdatabychangingthesystemconguration(numberof
measurement channels, options, etc.) of the opened setup data.
• OntheDX200P,youcanassignscreenstothe[4panel]displayandsetscreen
names.
• LoadtheDX100P/DX200P(hereinafter“theDXP”)setupdataviathecommunication
interface. Transmit setup data to the DXP (function available on DXP style S4 or later).
DXP
(Style S4 or later)
To the DXP
1
2
3
4
5
6
7
8
9
10
26
27
28
29
30
21
22
23
24
25
16
17
18
19
20
11
12
13
14
15
DISP/
ENTER
Communication
via
the Ethernet
ListSetup data Display the data
Save
Transmit setup data
Receive setup data
Save
CH01 VOLT OFF
CH02 TC OFF
CH03 RTD OFF
CH04 VOLT ON
CH01 TC ON
CH02 TC ON
CH03 TC ON
CH04 TC ON
CH01 VOLT OFF
CH02 VOLT OFF
CH03 VOLT OFF
CH04 VOLT ON
................
................
................
Create setup data
Setup data: Setup data of the DXP (.ppl extension).
Chapter 1 Before Using the DAQSTANDARD