Instruction Manual

2-32
IM04L41B01-65EN
Setting SNTP
SNTP client
function
SNTP server
function
• Basic
• SNTP server
Select [ON] when using the SNTP server function. The DXP sends time information
to SNTP clients on the network.
• SNTP client
Select [ON] when using the SNTP client function. The DXP queries time information
to an SNTP server on the network.
• Server name
Set the access destination of time information using up to 64 alphanumeric
characters. Set the server host name or IP address.
• Port Number
Set the port number of the SNTP server in the range from 1 to 65535. The default
value is [123].
• Access interval
Select the time interval for querying the time on the SNTP server from [Off], [1h], [8h],
[12h], or [24h]. Time is not queried if [Off] is selected.
• Access reference time
 Thetimeusedasareferenceforthetimequery.Thetimeisqueriedatthespecied
access interval with respect to this time.
Set the time in the range of 00:00 to 23:59.
• Access timeout
The timeout period for a response from the SNTP server. If no response is received
within this time period, time query will not be performed.
Select [10s], [30s], or [90s].
• SNTP synched to start (Time adjust on Start action)
 SetwhethertoquerythetimeusingtheSNTPclientfunction(ON/OFF)whendata
acquisition is started.
2.6 Configuring the System Mode