Instruction Manual

2-20
IM04L41B01-65EN
Remote (Option, /R1)
You can assign items to be controlled by the eight remote control terminals. This is
possible, if the remote function is available.
Scan Interval/Memory/Memory Timeup
Set these parameters when the data type is set to [EVENT & DISP] or [EVENT].
Click here (also selectable from [Setting] - [System Mode Setting]).
Check the channels you
wish to sample.
Select the
range.
Resets the
range selection.
Turn ON/OFF
at once.
A/D Integrate
100 ms can be selected only when the scan interval is set to [2 s].
Auto: The DXP will automatically switch between [60 Hz] or [50 Hz].
Scan Interval
The selectable scan intervals vary depending on the model as follows:
DX102P, DX104P, DX204P, DX208P: 125 ms and 250
DX106P, DX112P, DX210P, DX220P, DX230P: 1 s and 2 s
Memory Sample (Save Method of Measured/Computed Data)
• Data
 Whenthedatatypeis[EVENT],set[EventDataSamplingRate]and[DataLength].
The selectable data length vary depending on the sampling rate. However, if the type
of process is set to [Batch] in the application settings of the system mode tab (see
page 2-22), the maximum selectable time is automatically entered and cannot be
selected.
• Sampling
Select the channels whose data is to be saved to the memory.
 Tocollectivelyselectordeselectaspeciedrange,carryoutthefollowingprocedure.
1. Specify the range by dragging the mouse over the desired range on the column (if
youdonotcarryoutthisstep,allchannelsarespecied).Youcanresettherange
by pressing the Initialize button.
2. Theselected/deselectedconditionofthespeciedrangeofchannelsswitcheach
timetheON/OFFatoncebuttonisclicked.
2.6 Configuring the System Mode