User guide
7-72
M-4659
7.13 Sending Setup Data to the CX
If the CX is acquiring data to the memory, the setup data will not be sent to the CX. An
error message appears.
The setup data are sent when
[Comm] - [Send Setting] is selected.
A conrmation dialog box is displayed.
To send the new setup data to the CX, click the OK button. A message is displayed when
the transmission is complete. Click OK to close the message.
Note
Of the network settings in the [Setup] tab, the following items are not transmitted.
• [IP Address] under the [TCP/IP] tab
• All settings under the [Serial] tab.