Instruction Manual

7-7

IM 04L31A01-17E

Response

Setting Data/Basic Setting Data

• The FE command is used to output the data.

• The setting/basic setting data are output in the order of the listed commands in the

table in section 6.2, “A List of Commands.” However, the setting information for the

following commands is not output.

• Setting commands (setup)

SD/FR command

• Setting commands (control)

All commands from UD to CM

• Basic setting commands

XE, YO, YI, and YC commands

• The output format of the setting/basic setting data conforms to the syntax of each

command.

• Some commands are output in multiple lines. Commands that are specified for each

channel are such commands.

Syntax

The two-character command name and the succeeding parameters are output in the

following syntax.

CRLF

ttsss...s

CRLF

..............

CRLF

tt Command name(SR, SA..., XA, XI...)

sss...s Setting, basic setting data (variable length, one line)

Example

SR01,VOLT,20mV,0,20

SR02,VOLT,20mV,0,20

...................

7.2 Output Format of ASCII Data