Instruction Manual

6-7
IM 04L31A01-17E
Command
6
Note
• There are two execution modes on the CX. If you attempt to execute a command in a mode
that is different from the specification, a syntax error occurs. Use the DS command to switch
to the appropriate execution mode, then execute the command. Query commands can be
executed in either mode.
• Basic setting mode
Measurement, computation, and control are stopped, and settings are changed in this
mode.
• Operation mode
As a general rule, commands other than those for the basic setting mode described above
are used in this mode.
• The ADMINISTRATOR and USER specifications in the table indicate the user level that is
specified using the login function for Ethernet communications. For details, see section 2.7.
Command Command Function Execution mode ADMINISTRATOR USER Page
Type Name
Operation
UD Switches the screen Operation mode Yes No 6-36
PS Starts/Stops measurements Operation mode Yes No 6-37
AK Confirms the alarm status Operation mode Yes No 6-37
(alarm acknowledge)
EV Saves the manual sample, manual trigger, Operation mode Yes No 6-37
snapshot, display data, saves the event data
MS Writes the message (display and save) Operation mode Yes No 6-38
TL Starts/stops/resets computation (MATH) Operation mode Yes No 6-38
Clears the computation dropout status display
DS Switches execution modes All modes Yes No 6-38
(operation/basic setting)
LO Loads the setup data for setting commands Operation mode Yes No 6-38
LI Saves the setup data Operation mode Yes No 6-39
CM Sets the communication input data Operation mode Yes No 6-39
EM Starts/Stops e-mail messages Operation mode Yes No 6-39
DL Switches the operation mode for DIO Operation mode Yes No 6-39
operation monitoring
DM Sets the manual output value for Operation mode Yes No 6-39
DIO operation monitoring function
DP Starts/Stops e-mail messages Operation mode Yes No 6-39
Yes: Command usable
No: Command not usable
6.2 A List of Commands