Owner's manual
3-11
IM WX1-05E
1
2
3
Index
Detailed Description Functions
3.3 Messages and Corrective Actions
Error
No. Message Corrective Actions
E211 Cannot write to file. Check if the disk capacity is sufficient or if the file systems is normal.
E212 Cannot read file. Check if the file exists and is supported by the software or if the file system is
normal.
E213 Cannot open file. Check if the file exists and is supported by the software or if the file system is
normal
E401 Communication error. Check if the recorder connected for communication is powered on and if the
cable is properly connected. Also check the following items according the
communication type.
• For Ethernet
Check if address settings are correct; the TCP/IP protocol is installed in
Windows; the Ethernet card is properly installed.
• For RS-232 and RS-422-A
Check if the baud rate settings match; the port (COM1 to COM9) settings
match, the address settings are correct (RS-422-A); the serial port of the PC
is active and the appropriate cable is being used.
E402 Communication timeout. -
E403 Cannot open a communication
port.
Same as E401.
E501
Invalid license number. Please
reinstall the software.
Install the software again.
E1010 Execution of a process failed. Check whether an executable function exists, or whether its files are
damaged. If this error appears frequently, reinstall the software.
E1011 Execution of a service failed. Check whether an executable function exists, or whether its files are
damaged. If this error appears frequently, reinstall the software.
Message
No. Message
M1201 Model determination was successful.
M1210 Setting changes saved before execution.
Executable Function Messages
No. Message Corrective Actions
W[631] Data Lack Reduce the number of acquired data points or connected instruments, or
lengthen the scan interval.
E[673] Cannot open communication Same as E401.
E[674] Communication error Same as E401.
E[675] Communication time out Same as E401.
E[800] CRC check error A CRC error was detected. Check the communication status.
E[801] Invalid handle. Check the communication status.
E[802] Error respond Check the communication status.
E[804] Invalid command -
I[606] Recovery Communication Connection recovered.