Owner manual

2-16

IM WX103-01E

Setting the Remote RJC Reference Channel (Valid Only When the Input Mode Is

Set to RRJC (TC))

12. Select the reference channel for the remote RJC from the Ref. Ch. list box under

RRJC.

Note

If the reference channel setting for difference input or the reference channel setting for the

remote RJC is inappropriate when switching from the Channel screen to the Display or Monitor

screen, a Channel dialog box opens (see the figure below). To disable the measurement

channels with inappropriate settings (clear the Monitor check box on the Channel screen) and

move to the Display or Monitor screen, click Yes. To change the settings of the inappropriate

measurement channels without moving to the next screen, click No.

Setting the Unit, Tag Number, and Tag Comment

13. Click the Unit, Tag No., and Tag Comment text box and enter the unit, tag number,

and tag comment, respectively.

Setting the Time Constant of the First-Order Lag Filter (Valid Only When the

Input Mode Is Set to Something Other than DI)

14. Select the time constant from the Filter list box.

Setting the Burnout (Valid Only When the Input Mode Is Set to TC)

15. Select the direction in which the measured value is set off the range (+OVER or –

OVER) when a burnout occurs from the Burnout list box.

Setting the RJC (When the Input Mode Is Set to TC)

16. Click the Type box under RJC and select Internal or External.

17. If you select External, click the Volt box under RJC and enter the compensation

voltage.

Enter the tag comment

(up to 30 characters)

Enter the unit (up to six characters, only

when the Use check box of Scale is selected)

Enter the tag No.

(up to 15 characters)

Select the reference channel for the remote RJC

(valid only when the input mode is set to RRJC (TC))

Set the RJC

(valid only when the input

mode is set to TC)

Set the burnout

(valid only when the input mode

is set to TC)

Set the time constant of the first-order

lag filter

(when the input mode is other than DI)

2.4 Setting the Measurement Conditions (Measurement Channel Settings)