Instruction Manual

3-2
IM WX102-01E
3.2 Network Settings
To use Ethernet for communication with DA100/DC100/DR, it is necessary to first make
IP address, Subnet Mask, and Default Gateway settings for the DA100/DC100/DR.
Connection Method
Connect your PC to DA100/DC100/DR as described below. Connect only one DA100/
DC100/DR to one PC.
PC
Ethernet port
Ethernet module
Hub
10BASE-T cable
ETHERNET I/F
10BASE-T
DR
The Ethernet module mode must be the Set mode.
Network Settings
1
Switch on power of your PC and the DA100/DC100/DR, Startup DAQ 32 Plus and
select Software Configurator with the Launcher toolbar.
2
Click the Network tab to display the setting screen for IP address, Subnet Mask,
and Default Gateway (see below).
Network tab
Change after
colored blue
Dipswitch
position for
communication
mode
Dipswitch
position for
setting mode
Check button
3
Click the Check button to get the currently used settings. If this is the first time you
use the DA100/DC100/DR, initial values will get displayed.
4
If you click the digits in the IP address, Subnet Mask, or Default Gateway setting
boxes, the clicked part will be invertedly displayed, allowing you to change the
value.