User guide

2-40
IM WX101-01E
10. If necessary, specify the name of the data le in the “Extra le name” box.
The specied character string will be placed at the beginning of the le name. For
example, if “ABCD” is specied, the le names will be ABCD-0000.mld, ABCD-0001.
mld, etc. If it is not specied, the le names will be 000.mld, 0001.mld, etc. The le
extension “.mld” is xed.
11. If necessary, check the “Add Date” box.
If it is checked, an 8-digit number will be placed at the beginning of the
le name.
For example, if the les are recorded on January 25, 1999, the le names will be
19990125-0000.mld, 19990125-0001.mld, etc.
However
, if “per Hour” is specied for “File division” in step 11, a 10-digit number will
be plac
ed at the beginning of the le name. For example, if the le is recorded at the
15th hour (3 p.m.) on January 25, 1999, the le name will be 1999012515-0000.mld.
If the “Extra le name” is specied, the date will be added after the specied le
name as in ABCD-19990125-0000.mld.
12. In the “File division” list box, select the method of le division which is performed
when data is saved.
The list box shows 4 methods: “Off,” “Data count,” “per Day,” “per Hour,” and “per Month.”
If you select Data count, enter the number of data points to be saved in a le.
If you select per Day or per Hour, the le will be divided at 0 a.m. every day or at 0
minute every hour, respectively.
For “per Month,” select a reference day (1-28). A le from just after 0 hours, 00
minutes, 00 seconds until the last recorded data is created. Data at 0 hours, 00
minutes, 00 seconds is saved in the next le.
13. If necessary, click the Comment button for the Comment setting eld. Enter the Title
and Content of the comment. Up to eight title and content sets can be entered. Up
to sixteen alphanumeric characters can be used for titles, and up to sixty-four can be
used for contents.
Note
You can change the comments during data scanning, or while data scanning is paused.
Comments cannot be changed during data recording. They can only be displayed.
14. If you want to limit the number of data les that are saved to the folder for a single
measurement, select the “Keep the number of recording les” check box, and enter
the maximum number of les from 1 to 2000. If creating a data le causes this limit
to be exceeded, the oldest data le that was created during the measurement is
deleted.
2.9 Configuring the Logger