User guide

7-103
IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
• Send delay [second]
Set the delay between POP3 server authentication and transmission to a value from 0
to 10 seconds.
• POP3 Login
To encrypt the password when logging into the POP3 server, select APOP. To send it
in plain text, select PLAIN.
Auth. Settings (Release number 4 or later)
To enable support for authenticated e-mail transmission (Authentication SMTP), set a
user name and password to use for authentication.
• User name
Enter the user name. You can enter up to 32 characters.
• Password
Enter the password. You can enter up to 32 characters. The password is displayed
as “**********.”
Alarm
Specify the settings for sending e-mail when alarms occur.
• Recipient1 and Recipient2
Set the e-mail recipients. For Recipient1 and Recipient2, select [ON] to send e-mail
or [OFF] to not send e-mail.
• Active alarms
Sends an e-mail when an alarm occurs. You can select [ON] (send e-mail) or [OFF] (not
send e-mail) for alarms 1 to 4.
• Include INST
Select [ON] to attach instantaneous value data to e-mail. The data that is attached
to an e-mail is the instantaneous value that is measured at the time the e-mail is
transmitted.
• Include source URL
Select [ON] to attach the source URL. Attach the URL when the Web server is enabled.
• Subject
Enter the subject of the e-mail using up to 32 alphanumeric characters. The default
setting is Alarm_summary.
• Header1, Header2
Enter header 1 and header 2 using up to 64 characters.
• Send alarm action (Release number 3 or later)
To send an e-mail when an alarm occurs and when it is cleared, select [ON+OFF]. To
only send an e-mail when an alarm occurs, select [ON].
• Include tag/ch in Subject (Release number 3 or later)
Select [ON] to include a tag number in the subject. If the tag number is not set, the
corresponding channel number is included.
7.7 Setting DX1000/DX2000