User guide

1-6
IM WX101-01E
• The original SET mode and SETUP mode information can be
• Loaded from the recorder via communications (receive via communications).
• Loaded from a le that is stored on a storage medium such as a oppy disk (this
is called “le importing”).
• Created from scratch.
• The settings after they are edited can be
• Written to the recorder via communications (transmit via communications).
• Stored on a storage medium and written to the recorder from the storage
medium (this is called “le exporting”).
However, the following restrictions exist depending on the recorder:
• Settings for the DX1000 and DX2000 cannot be processed by the setting
software.
• For µR recorders, the SET Mode settings can be transmitted or received via
communications.
Settings in the SETUP
Mode cannot be modied. Set them directly on the µR
recorder. In addition, since no storage media drives are provided, setting using
the storage medium is not possible.
•
For VR recorders, the SET Mode settings can be transmitted or received
via communications or imported or exported through les. The settings
in the SETUP Mode can be modied through le importing and exporting.
Communications cannot be used.
• For DX/CX DAQSTATION and MV MobileCorder
, the setting mode and basic
setting mode settings can be transmitted or received via communications or
imported or exported through les. However, network settings (such as the IP
address) cannot be changed via communications. Set them directly on the DX
or use le exporting.
•
For DARWIN, the SET Mode and SETUP
Mode settings can be transmitted or
received via communications or imported or exported through les.
• If you are using a DX1000/DX1000N/DX2000 with the /AS1 option on which
users are registered, you cannot use serial communication to transmit settings.
• In addition, Hardware Congurator can be used to create settings by changing the
system conguration such as the presence or absence of options or by changing
the subunit/module conguration (for DAR
WIN). Use this function in situations
such as when preparing the conguration change of the connected recorder
beforehand.
•
The following
control commands can be transmitted to the recorders.
• Set the date and time of the recorder to the date and time of the PC (µR, VR,
DX, MV, CX, DA, DR, and DC).
• Start/Stop the recording (µR, DX, MV, CX, DR, and DC).
• Start/Stop computation (µR, VR, DX, MV
, CX, DA, DR, and DC).
• Initialize the data memory (VR, DX, MV, CX, DC).
• Show the specied display (µR, VR, DX, MV, CX, DR, and DC).
• Execute reconguration (DA, DR200 (Expandable), and DC).
However, if you are using a DX1000/DX1000N/DX2000 with the /AS1 option on
which users are registered, you cannot use serial communication to transmit control
commands.
For the operation procedure of Hardware Congurator
, see chapter 7.
• Report Generator
Determines the instantaneous value, maximum, minimum, average, sum, and total
from the data that are scanned or recorded over an hour, a day, a week, or a month
and output them to a le or print them at a specied time. Report Generator never
appears on the screen. The start and stop operation and settings of the report are
done on Software Manager.
1.1 Overview of the DAQLOGGER/DAQLOGGER Client Package