Owner manual

3-10
IM WX1-07E
3.5 Error Messages and Corrective Actions
A message (such as an error message) may appear during operation. The following
describes the meanings of the messages and their corrective actions.
Error
Code Description Corrective Action
E211 Cannot write to the file. Confirm that the disc capacity and file system are correct.
E212 Cannot read file. Confirm that a file exists, that the software supports it, and
whether the file system is correct.
E213 Cannot open the file. Confirm that a file exists, that the software supports it, and
whether the file system is correct.
E501 Invalid license number. Please reinstall. With the Gate series, the number of licenses purchased is the
limit for the number of programs run at the same time. Reinstall
the software.
E1010 Execution failed. Confirm that the file is not corrupt. If this error appears repeatedly,
reinstall the software.
Message
Code Description
M1210 Save the setting changes and try again.
Messages during (When Executing) Data Acquisition
Code Description Cause/Corrective Actions
W[631] Data Lack Data was unexpectedly lost. Reduce the number of acquired data
points or connected instruments, or lengthen the scan interval.
E[674] Communication error Communication Errors
Check whether the power to the connected measuring
instruments with which you wish to open communications is ON,
and whether the cables are connected correctly. Also check the
following.
• For Ethernet
Is the address correct, is the TCP/IP protocol installed in
Windows, and is the Ethernet card installed correctly?
• For RS-232 and RS-422-A
Are t
he baud rate, port numbers (COM1–COM9), and addresses
(RS422) correct? Is the PC serial port valid? Is the cable type
correct?
E[675] Communication time out Communication timeout
Same as E[674].
E[800] CRC check error CRC check error
A CRC error was detected. Check the communication status.
E[801] Invalid handle Failed to get communication handle.
Check the communication status.
E[802] Error respond Invalid data received.
Check the communication status.
W[880] Do not specify communication port Specify the communication parameters.
W[881] Current connecting model
configuration is mismatch!
The model is:
Change the parameters for the main unit.
W[884] Retry connection Connection recovered.