Owner manual

3-5
IM WX1-07E
Functions
1
2
3
Index
Error Status
The following shows the error statuses supported by each model. Also, the statuses are
modified as shown before transfer to DAQLOGGER and Remote Monitor.
UTAdvanced Series, Green Series, UT100 Series, US1000
Device Data Status Data Display after Change
PV1 A/D converter error ILLEGAL
PV1 RJC error ILLEGAL
PV1 overscale +OVER
PV1 underscale -OVER
PV2 A/D converter error ILLEGAL
PV2 RJC error ILLEGAL
PV2 overscale +OVER
PV2 underscale -OVER
VJ Series
Device Data Status Data Display after Change
EEP error ILLEGAL
EEP sum error ILLEGAL
Low cut status -OVER
A/D burnout ILLEGAL
RJC error ILLEGAL
M Series
Device Data Status Data Display after Change
Low cut status -OVER
Input over +OVER
Input under -OVER
EEP sum error ILLEGAL
Parameter error ILLEGAL
RJC error ILLEGAL
EEP error ILLEGAL
Note
• When connected to a UT52A or UT55A, if a PV1 A/D converter error occurs, the PV1 value
is displayed instead of ILLEGAL.
• When connected to a UT52A or UT55A, if a PV2 A/D converter error or a PV2 RJC error
occurs, the PV2 value is displayed instead of ILLEGAL.
• When connected to a UT32A, UT35A, UT52A, or UT55A, if a PV1 RJC error occurs, the
PV1 value is displayed instead of ILLEGAL.
• A/D converter and RJC errors (PV1 and PV2 ) of the UP55A are not supported.
3.3 Details on Functions