Instruction Manual
3-9
IM WX1-04E
1
2
3
Index
Detailed Description of Functions
3.3 Message and Corrective Actions
Error
No. Message Corrective Actions
E211 Cannot write to file. Check if the disk capacity is sufficient or if the file systems is
normal.
E212 Cannot read file. Check if the file exists and is supported by the software or if the file
system is normal.
E213 Cannot open file. Check if the file exists and is supported by the software or if the file
system is normal
E401 Communication error. Check if the recorder connected for communication is powered on
and if the cable is properly connected. Also check the following
items according the communication type.
• For Ethernet
Check if address settings are correct; the
TCP/IP
protocol is
installed in Windows; the Ethernet card is properly installed.
• For RS-232 and RS-422
Check if the baud rate settings match; the port (COM1 to COM9)
settings match, the address settings are correct (RS-422); the
serial port of the PC is active and the appropriate cable is being
used.
E402 Communication timeout. –
E403 Cannot open a communication port. Same as E401.
E501
Invalid license number.
Please reinstall the software.
Install the software again.
E1010 Execution of a process failed. Check whether an executable function exists, or whether its files
are damaged. If this error appears frequently, reinstall the software.
E1011 Execution of a service failed. Check whether an executable function exists, or whether its files
are damaged. If this error appears frequently, reinstall the software.
E1301 Cannot connect OPC server. Check whether the OPC server is available.
E1302 Execution of status display function failed. Check whether an executable function exists, or whether its files
are damaged. If this error appears frequently, reinstall the software.
E1303 Failed to create group. An error was returned from the OPC server when creating a group.
Check the status of the OPC server.
E1304 Failed to create item. An error was returned from the OPC server when creating an item.
Check the status of the OPC server.
Warning
No. Message Corrective Actions
E1401 Computer not found. Check whether the specified computer exists on the network, or
whether the network is functioning normally.
Message
No. Message
M1201 Model determination was successful.
M1210 Setting changes saved before execution.
M1501 Delete server?
M1502 Delete selected item?
M1503 Delete selected group?