Manual

4-6
IM MV1000-17E
Group/Command
Name
Function Execution Mode Administrator User See
Page
Setting (continued)
YL Sets Modbus master function settings
Basic Setting Mode Yes No 4-37
YM Sets a Modbus master transmission command
Basic Setting Mode Yes No 4-37
WR Sets the instrument information output
Basic Setting Mode Yes No 4-38
XE Activates Basic Setting Mode
Basic Setting Mode Yes No 4-38
YE Activates Basic Setting Mode (cold reset)
Basic Setting Mode Yes No 4-39
Yes: Command usable
No: Command not usable
Output Commands
Group/Command
Name
Function Execution
Mode
Administrator User See
Page
Control
BO Sets the byte output order
All modes Yes Yes 4-39
CS Sets the checksum (can be used only during serial
communications)
All modes Yes Yes 4-39
IF Sets the status filter
All modes Yes Yes 4-39
CC Disconnects the Ethernet connection
All modes Yes Yes 4-39
(can be used only during Ethernet communications)
CB Sets the data output format
All modes Yes Yes 4-40
Setup, measurement, and computed data output
FC Transmits screen image data
All modes Yes Yes 4-40
FE Transmits setup data
All modes Yes Yes 4-40
FD Transmits most recent measured/computed data Operation Mode Yes Yes 4-40
FF Transmits FIFO data Operation Mode Yes Yes 4-41
FL Transmits a log, alarm summary, or message
summary
All modes Yes Yes 4-41
IS Transmits status information
All modes Yes Yes 4-41
FU Transmits the user level
All modes Yes Yes 4-41
FA Transmits instrument information
All modes Yes Yes 4-42
ME Transmits data stored on an external storage
medium or the internal memory (can be used
through either Ethernet or serial communications)
Operation Mode Yes No 4-42
MO Manipulates or transmits data stored in the internal
memory
Operation Mode Yes No 4-42
RS-422/485 commands
Esc O Opens a instrument All modes Yes Yes 4-43
Esc C Closes a instrument All modes Yes Yes 4-43
Common command
*I Transmits instrument information
All modes Yes Yes 4-43
Yes: Command usable
No: Command not usable
4.2 A List of Commands