Manual
3-14
IM MV1000-17E
Conguring the MV1000 Slave (Modbus Slave)
Configuring the Modbus Slave
◊ Press MENU and then select Menu tab > Basic setting mode > Menu tab >
Communication (Serial) > Basic settings
Parameter Setting
Address 1
Protocol Modbus
*
Set the communication parameters the same as those of the master device.
Configuring Measurement Channels
◊ Press MENU and then select Menu tab > Meas channel > Range, Alarm
Parameter Setting
First channel and last channel 1
Mode Volt
Range 2V
Span_L –2.0000
Span_U 2.0000
3.6 Usage Example of the Modbus Function